Vibration Damper, Removing And Installing: Installing

Install in the reverse order of removal while noting the following:

Requirement

• All contact surfaces in between the bolt, vibration damper and three stage chain sprocket must be free of grease.

-- Make sure the tooth contour -arrow- is in "TDC" position.

Fig 1: Identifying TDC

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Position the vibration damper in "TDC" position.

-- Attach the turning over tool -A- on the Assembly Tool:T10531/6  .

Fig 2: Identifying Turning Over Tool And Collar Nut

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Requirement

• The hex fitting must face toward the vibration damper.

-- Attach the collar nut -B-.

Requirement

• Slightly move the vibration damper back and forth to make sure the vibration damper is seated correctly into the tooth contour.

-- Tighten the collar nut -B- until the vibration damper can no longer be turned.

-- Attach the mount -A- to the vibration damper -4- and install the knurled bolts -B- by hand.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Requirement

• The marking on the mount -A- must point upward.

-- Align the adapter -C- at the inner hex socket -2- using a commercially available 4 mm hex socket wrench and counterhold.

-- Loosen the collar nut -A- and the adjusting bolt -B-.

Fig 3: Identifying Collar Nut And Tensioning Bolt

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Screw out the Assembly Tool:T10531/6  and remove using the turning over tool -A-.

-- Lubricate the O-ring -1- with clean engine oil.

Fig 4: Identifying Vibration Damper Bolt And O-Ring

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Insert the new vibration damper bolts with an O-ring -1- by hand.

-- Remove the knurled bolts -B- and remove the mount -A-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the adapter -C-.