Center Console Switch Module 1 -EX23- /Center Console Switch Module 2 -EX30-, REMOVING AND INSTALLING: Removing
-- Switch off the ignition and all electrical equipment.
-- Place the ignition key and other drive authorization systems outside of the vehicle interior, to avoid an unintentional start of the vehicle.
-- Unclip the shift lever boot upward out of the center console. Refer to the appropriate Service Information .
-- Pry out the trim -1- using the Removal Wedge Set:VAS895015 .
-- Pry out the center console switch module -1 and 2- using the Removal Wedge Set:VAS895015 .
-- Disconnect the connector.
-- Remove the Center Console Switch Module -1 and 2-.
If the driver side button module can not be removed as described, then:
-- Remove the center console insert. Refer to CENTER CONSOLE INSERT, REMOVING AND INSTALLING .
-- Unclip the Center Console Switch Module from the underside of the center console insert.