Drive Axle, Removing And Installing: Installing

WARNING: This page is about a different car, the 2023 Volkswagen Arteon. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

-- Insert the bolt -4- with the washer -3-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Slide on the washer -2-.

-- Tighten the nut -1-.

-- Release the tension of the spring -4- and at the same time pay attention that the upper spring is seated on the body tab.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the Spring Tensioner -3-.

Spring Compressor Kit - Spring Retainer with Inserts:V.A.G 1752/3A
Spring Compressor Kit - Adapter Blocks:V.A.G 1752/9
Spring Compressor Kit - Spring Tensioner:V.A.G 1752/1
Spring

Only fasten the threaded connections on the wheel bearing housing in the curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .

-- For vehicles with a level control system sensor, perform the basic setting using the Vehicle Diagnostic Tester.