Electronic Damping Control Module -J250-, REMOVING AND INSTALLING, PASSAT SEDAN: Removing

WARNING: This page is about a different car, the 2023 Volkswagen Arteon. However, it is still accessible from the selected car via links, so may be relevant.

Component location: the Electronic Damping Control Module -J250- is installed in the luggage compartment behind the right side trim panel.

-- Disconnect the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Switch the ignition off and open the driver door so the steering wheel lock engages.

-- Open the access cover for the right luggage compartment side trim panel.

-- If equipped, disconnect the connectors for the Digital TV Tuner -R171-.

-- Remove the nuts -arrows-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bracket -1- with the Electronic Damping Control Module -J250- from the stud bolts and place it in the passenger compartment.

-- Release the release lever -1- in the -direction of the arrow-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connector -2- from the Electronic Damping Control Module -J250- -3-.

-- Push the tab -1- in the -direction of the arrow-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the Electronic Damping Control Module -J250- -2- from the bracket -3-.