Electronic Damping Control Module -J250-, REMOVING AND INSTALLING, PASSAT SEDAN: Installing
WARNING: This page is about a different car, the 2023 Volkswagen Arteon. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- If the Electronic Damping Control Module -J250- has been replaced, the Replace control module function must be performed using the Vehicle Diagnostic Tester.
-- If the control position was reprogrammed on a vehicle with lane assist, then the driver assistance systems front camera must be recalibrated. Refer to DRIVER ASSISTANCE SYSTEMS FRONT CAMERA, CALIBRATING .