Diagnostic Entries
WARNING: This page is about a different car, the 2023 Volkswagen Arteon. However, it is still accessible from the selected car via links, so may be relevant.
After performing the following steps, the adaptation values must be adapted:
- Engine was replaced
- The sensor wheel for the Engine Speed Sensor -G28- was replaced
- The components of the chain drive were removed and installed or replaced
- The cylinder head was removed and installed or replaced
- The camshafts were removed and installed or replaced
- The Engine Temperature Control Actuator -N493- was replaced
- The turbocharger or the Charge Air Pressure Control Module -GX34- was replaced
- The Throttle Valve Control Module -GX3- was replaced.
- Particulate filter was replaced
Adjust the Adaptation Values after "replacing components"
- 0001 - Engine Electronics
- 0001 - Engine electronics functions
- 0001 - Steps after replacing components