Right Seal On Bevel Box, Replacing

WARNING: This page is about a different car, the 2023 Volkswagen Arteon. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Seal Installer - Flange Shaft:T10049

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
Puller - Crankshaft/Power Steering Seal:T20143

Fig 1: Crankshaft / Power Steering Seal Puller
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
Sealing Grease. Refer to the appropriate Electronic Parts Information.

Procedure

The transmission is installed.

-- Remove the right flange shaft.

-- Remove the right seal using the Puller - Crankshaft/Power Steering Seal :T20143/2 .

-- Coat the outer edge and sealing lips on the new seal with transmission fluid.

Fig 2: Identifying Oil Seal

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Fill the space between the sealing/dust lip -arrow- halfway with sealing grease. Refer to the appropriate Electronic Parts Information for the correct sealing grease.

-- Drive the new seal all the way in using the Seal Installer - Bevel Box:T10049 . Do not tilt it while doing so.

Fig 3: Driving In New Sealing Ring To Stop Using Thrust Piece T10049

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the right flange shaft.

-- Gear Oil, Checking Level. Refer to GEAR OIL, CHECKING LEVEL .