Outer Rear Three-Point Seat Belt, Removing And Installing: Installing

WARNING: This page is about a different car, the 2023 Volkswagen Arteon. However, it is still accessible from the selected car via links, so may be relevant.

Vehicles with Seat Belt Tensioner

Install in the reverse order of removal while noting the following:

NOTE:

Observe the general safety precautions for pyrotechnical components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .

If parts of the seat belt system are removed due to an accident, replace the belt system bolts.

CAUTION:

Pyrotechnical components can deploy unintentionally.

Risk of injury.

- Discharge static electricity: briefly touch the door striker.

-- If parts of the seat belt system are removed due to an accident, replace the belt system bolts.

-- Insert the automatic belt retractor with the anti-twist mechanism -1- in the mount -2- in direction of -arrow- and tighten the bolt.

Fig 1: Identifying Anti-Twist Mechanism & Mount

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

CAUTION:

Risk of injury due to involuntary deployment of pyrotechnic components.

- Always connect the battery when the ignition is switched on.

- There must not be anyone in the vehicle interior when connecting the battery.

- If the ignition is not switched on after the battery is reconnected, only switch on the ignition with the driver seat in the rearmost position.

-- Connect the battery ground cable with the ignition switched on. Refer to BATTERY, DISCONNECTING AND CONNECTING .

NOTE:

Make sure the connectors are pushed in all the way and that they engage audibly.

Install in reverse order of removal.