Airbag Control Module -J234-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2023 Volkswagen Arteon. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Pyrotechnical components can deploy unintentionally.

Risk of injury.

- Discharge static electricity: briefly touch the door striker.

Install in reverse order of removal and note the following:

NOTE:

Make sure the connectors are pushed in all the way and that they engage audibly.

CAUTION:

Risk of injury due to involuntary deployment of pyrotechnic components.

- Always connect the battery when the ignition is switched on.

- There must not be anyone in the vehicle interior when connecting the battery.

- If the ignition is not switched on after the battery is reconnected, only switch on the ignition with the driver seat in the rearmost position.

-- Connect the battery ground cable with the ignition switched on. Refer to BATTERY, DISCONNECTING AND CONNECTING .

NOTE:

If the Airbag Indicator Lamp -K75- indicates a fault after installing, check the DTC memory, erase it and check it again using the Vehicle Diagnostic Tester.

The Airbag Control Module -J234- must be coded after replacing it using the Vehicle Diagnostic Tester.