Glove Compartment Lid Service Position
Moving into Service Position
- Glove compartment lid -2- is open.
-- Push the stops -1- for the glove compartment lid -2- upward -A arrows-.
-- Carefully open the glove compartment lid -2- approximately 5 cm -arrow B-.
Do not exceed the 5 cm, otherwise the brake component shaft can be removed from the damper.
-- Move/release the steering rack -1- in -direction of the arrow- and remove it from the glove compartment lid.
If when moving into service position the brake component is removed from the damper, guide it back into the damper. Pay attention to the correct installation position.
If when "moving to service position" the damping element falls out of the damper, insert back into the damper and at the same time pay attention to the correct installation position.
Service Position, Resetting
-- Slowly close the glove compartment lid.
-- Close the glove compartment lid further and lock behind the end stops.