Repair Kit For FLEXRAY Wires With Coating

WARNING: This page is about a different car, the 2023 Volkswagen Arteon. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The repair of FlexRay wires with coating can only take place using FlexRay wires with coating from the appropriate Electronic Parts Information.

A two-layer wire -1 and 2- with a 0.35 mm ² profile is used as a FlexRay wire.

Fig 1: Identifying Repair In Twisted Wire Pairs

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

During repair work, both wires must have the same length.
When twisting the wires -1 and 2- together, the -A- = 30 mm routing length must be maintained.
While doing so, no section of wire may be greater than -B- = 50 mm without twisting the wires, for example in the area of crimp connectors -arrow-.
Maximum exposed wire length: -C- = 100 mm.

Fig 2: Identifying Exposed Wire
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
Protect the area from environmental conditions using appropriate actions. Use a crimp connector with heat-shrinkable tube over the untwisted location being repairs and waterproof insulation over the exposed wire.
Mark the location of the repair with something suitable, for example, with yellow tape.
Repairing both wires is identical to repairing just one wire.
Position both repaired location -arrows- -A- = 30 mm opposite each other.
The crimping of cable ends with connectors has to be done the same way.

1 - Repair location in the area without insulation

2 - Repair location with connectors

C - Maximum exposed length = 100 mm