6-Pin Universal Oxygen Sensor, Replacing

WARNING: This page is about a different car, the 2023 Volkswagen Arteon. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Use the faulty sensor as a guide for installing all of the accompanying attachments, cable ties or marking bands.

Do not crimp or cut the wires otherwise the functionality of the heated oxygen sensor (HO2S) will be diminished.

-- Remove the old heated oxygen sensor (HO2S).

-- Lay both of the oxygen sensor next to each other so the sensor housings are the same level.

Fig 1: Identifying Both Oxygen Sensors

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tie the excess length of the sensor (approximately 50 to 250 mm) back so it is the same length as the faulty sensor and secure it with cable ties -1-.

Fig 2: Identifying Excess Length Of Sensor Tied To Same Length As Faulty Sensor

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the new oxygen sensor in the vehicle.