Repair Information
Materials
|
(1)2)3) | ||||
|
(1)2)3) | ||||
|
(1)2)3) | ||||
|
(1)2) | ||||
|
(1)2) | ||||
|
2 | ||||
|
2 | ||||
|
|||||
2) Refer to the appropriate Electronic Parts Information for the part numbers for the materials.
3) Use only new and originally packed chemical materials which are within the indicated storage life.
Assembly Instructions
The spoiler cannot be removed without damaging it.
The temperature of the room, the work station and the vehicle must be roughly the same.
Make sure to meet the processing temperature of 18 °C to 35 °C (64.4 °F to 95 °F).
Thoroughly clean the adhesive surface on the rear lid and spoiler using a new lint-free cleaning cloth and cleaning solution immediately before installation. Adhere to the flash-off time of 30 minutes. The adhesive surfaces must be dry.
- The general information for adhesive must be observed. Refer to ADHESIVES, GENERAL INFORMATION ABOUT APPLICATION .
- For the following procedures, the guidelines for temperature, cleaning, removal of adhesive residue and the installation must be met. Refer to COMPONENTS WITH ADHESIVE TAPE, INSTALLATION PREPARATION .
Minimum curing time for newly bonded spoiler is 72 hours.
Minimum curing time is the time from applying the spoiler up to vehicle use.