LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2023 >> ID.4 S >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Exterior Equipment) >> 66 Exterior Equipment >> Moldings, Trims, Extensions And Trim Panels >> Trim Molding, Removing And Installing >> Rear Lid Trim Molding, Removing And Installing >> Removing

Rear Lid Trim Molding, Removing And Installing: Removing

WARNING: This page is about a different car, the 2023 Volkswagen Arteon. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

The trim molding cannot be removed from the two-sided adhesive tape without destroying it.

The trim molding must be replaced after removal.

-- Warm the trim molding before removal using the Hot Air Blower:V.A.G 1416  .

-- Remove the trim molding.

scientia non olet · About LEMON Manuals