LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2023 >> ID.4 S >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Exterior Equipment) >> 66 Exterior Equipment >> Moldings, Trims, Extensions And Trim Panels >> Side Sill Trim Panel, Removing And Installing >> Assembly Instructions >> Notes

Assembly Instructions: Notes

WARNING: This page is about a different car, the 2023 Volkswagen Arteon. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Make sure the adhesive surfaces are free of dust, grease and dry.

The temperature from the vehicle, work station and component must be the same. The processing temperature is minimum 20 °C (68 °F) and maximum 35 °C (95 °F).

Clean the adhesive surface with cleaning solution and a lint-free cleaning cloth, and then let dry for 10 minutes.

Maintain the minimum curing time at processing temperature for 60 minutes.

scientia non olet · About LEMON Manuals