Engine Temperature Control Actuator N493, Removing And Installing: Installing
WARNING: This page is about a different car, the 2023 Volkswagen Arteon. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Make sure that the O-rings -4- are seated correctly.
-- Make sure that the alignment pins are inserted into the cylinder block.
-- Install the connection piece -2- into the engine oil cooler -1-.
-- Refer to Cooling System, Filling .
If the Engine Temperature Control Actuator -N493- Has Been Replaced, Adaptations must be Performed:
-- Perform the "Adaptations after component replacement" using the Vehicle Diagnostic Tester. Refer to the appropriate Service Information .
Continuation