Perform a leak detection test on a refrigerant circuit that is filled with refrigerant:
WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.
-- Switch off the ignition.
-- Start up the leak detector in line with relevant operating instructions.
-- Always hold the test probe underneath the suspected leak.
Depending on the model, leak detection is indicated by an increase in clicking rate or a warning tone. Refer to the Leak Detection Device Owner's Manual.
NOTE:
Currents of air quickly disperse refrigerant gas. Drafts must therefore be avoided during leak detection.
Refrigerant gas is heavier than air and will escape.