LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2023 >> ID.4 S >> Repair and Diagnosis >> External Pages >> Different car >> Section 127 (Air Conditioning (Heating, Ventilation And Air Conditioning)) >> 87 Air Conditioning >> A/C Compressor >> Belt Pulley, Removing And Installing >> BELT PULLEY, REMOVING AND INSTALLING, A/C COMPRESSOR WITH A/C Clutch -N25- >> Belt Pulley, Removing

Belt Pulley, Removing

WARNING: This page is about a different car, the 2023 Volkswagen Arteon. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

If the belt pulley -A- (after removing the circlip) cannot be removed from the A/C compressor flange by hand (because of debris, for example), carefully remove the belt pulley as described below.

Fig 1: Removing Belt Pulley
GWWA87-11104Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Mount the arms on the puller so that the outside of the belt pulley does not get bent if the belt pulley -A- is going to be used again.

-- Remove the belt pulley -A- with a 3-arm puller -B-.

NOTE:

Do not support the puller spindle -B- on the A/C compressor shaft when removing the belt pulley -A-.

Use a sleeve -C- (for example, Sleeve VAG 1719/1 taken from A/C Clutch Set:VAG1719  ) to support the spindle on the arm puller -B- on the A/C compressor flange.

Clean the flange on the A/C compressor thoroughly after removing the belt pulley -A-. It must possible to install the belt pulley -A- by hand.

scientia non olet · About LEMON Manuals