, Removing

WARNING: This page is about a different car, the 2023 Volkswagen Arteon. However, it is still accessible from the selected car via links, so may be relevant.

Removal is performed in the reverse order.

-- Always only remove one locating pin and replace it with a new bolt.

-- For vehicles with a level control system sensor, perform the basic setting using the Vehicle Diagnostic Tester.

Tightening Specifications

Refer to OVERVIEW - SUBFRAME
Pendulum support bolts. Refer to OVERVIEW - ASSEMBLY MOUNTS .
Noise insulation bolts. Refer to OVERVIEW - NOISE INSULATION .

If the steering wheel is still crooked after using the Locating Pins:T10486/1 then an axle alignment is necessary. In this case record it in the vehicles axle alignment log.