Overview - Rear Lid
WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.
- Rear Lid
- Removing and Installing. Refer to REAR LID, REMOVING AND INSTALLING .
- Adjusting. Refer to REAR LID, ADJUSTING .
- Rear Lid Closing Aid -VX16-
- Removing and Installing. Refer to CLOSING ASSIST, REMOVING AND INSTALLING .
- Rear Lid Handle -EX37-
- Removing and Installing. Refer to ACTUATOR, REMOVING AND INSTALLING .
- Rear Lid Lock Unit -VX25-
- Removing and Installing. Refer to LATCH, REMOVING AND INSTALLING .
- Hex Nuts
- 20 Nm
- Quantity: 2
- Adjusting Buffer
- Left and right
- Adjusting. Refer to REAR LID, ADJUSTING .
- Ball Stud Mounting Bracket
- Not installed in all models
- Left and right
- On the rear lid
- Only installed in the ball stud, the tightening specification for the ball stud is 20 Nm + 45°
- Bolts
- 10 Nm + 90°
- Quantity: 2 on each side
- Pinch Protection
- Left and right
- Removing and Installing. Refer to Pinch Protection Sensor -G673- AND Pinch Protection Sensor 2 -G753-, REMOVING AND INSTALLING .
- Rear Lid Drive Unit -VX69-
- Rear Lid Drive Unit, Removing and Installing. Refer to REAR LID DRIVE UNIT, REMOVING AND INSTALLING .
- Gas-Filled Strut
- Removing and Installing. Refer to GAS-FILLED STRUT, REMOVING AND INSTALLING .
- Venting. Refer to GAS-FILLED STRUT, VENTING .
- Ball Stud Mounting Bracket
- Left and right
- On the side panel
- Bolts
- 10 Nm + 90°
- For the mounting bracket
- Quantity: 2 on each side
- Nut
- 20 Nm + 45°
- Quantity: 1 per hinge
- Bolts
- 10 Nm
- Quantity: 2 per hinge
- Hinge
- Removing and Installing. Refer to HINGE, REMOVING AND INSTALLING .
- Left and right
- Rubber Grommet
- Removing and Installing. Refer to REAR LID, REMOVING AND INSTALLING .