Latch With Closing Assist, Removing And Installing: Removing
If the rear lid does not open, use the emergency release -3- inside the rear lid trim panel to open it manually. Refer to the appropriate Service Information.
-- Remove the rear lid trim panel. Refer to REAR LID LOWER TRIM PANEL, REMOVING AND INSTALLING .
-- Remove the latch cover -5-.
-- Disconnect the connector -4- from the latch -1-.
-- Remove the hex nut -2- and remove the latch -1- from the threaded pin.
-- At the same time the retaining hooks -6- loosen from the rear lid.
-- Lock the locking catch -7- from the latch locking mechanism -4-.
-- Push the lever -6- all the way with the screwdriver -5- in the direction of -arrow c- and hold.
-- Remove the release cable -1- from the retainer -arrow b-.
-- Guide the release cable -1- out of the lever -2- in direction of -arrow c-.