Crankshaft, Measuring Axial Clearance

WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Dial Indicator Holder:VW 387

Fig 1: Dial Gauge Holder
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
Dial Indicator - 0-10mm:VAS 6079

Fig 2: Dial Gauge
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Test Sequence

Fig 3: Attaching Dial Indicator Together With VW 387 Dial Gauge Holder To Cylinder Block And Set Indicator Against Crankshaft Counterweight

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Use the Dial Indicator Holder:VW 387 to attach the Dial Indicator - 0-10mm:VAS 6079 to the cylinder block and place it against the crankshaft counterweight.

-- Push the crankshaft against the Dial Gauge by hand and set the Dial Gauge to "0".

-- Remove the crankshaft from the dial gauge and read the measurement.

Axial clearance:

New: 0.07 to 0.23 mm
Wear limit: 0.30 mm