Door, Adjusting

Special tools and workshop equipment required 

• Adjustment Gauge:3371 
• Wrench - Door Adjusting:3320 

Preparing

Conditions

• When adjusting the door, the vehicle must be resting on its wheels on a level surface.
• The door must engage in the striker without great force.

The door is correctly installed, when it is closed and:

• The gap dimensions are even.
• The contours align.
• The door is not positioned too far inward or outward.

The procedure shown is for the left side of the vehicle as an example.

Gap Dimensions, Adjusting

-- Remove the B-pillar lower trim panels. Refer to B-PILLAR LOWER TRIM PANEL, REMOVING AND INSTALLING .

-- Loosen the bolts -1, 2, 3 and 4-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Check the gap dimensions using the Gauge - Gap Adjustment:3371  . Refer to DOOR, ADJUSTING , for this.

-- Tighten the bolts -1, 2, 3 and 4-.

Flush Dimension, Adjusting

-- Loosen the bolts -1 and 2- using the Wrench - Door Adjusting:3320  and the respective bit.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Check the gap dimensions using the Gauge - Gap Adjustment:3371  . Refer to DOOR, ADJUSTING , for this.

-- Refer to Striker, Adjusting  .

-- Tighten the bolts -1 and 2-.

Tightening Specifications

• Refer to Overview - Door  .