Glass Panel, Removing And Installing: Installing
Glass Panel that is Not Destroyed
-- Refer to Undamaged Window Glass, Preparing for Installation .
New Glass Panel
Tip
The adhesive surface is shown on the glass panel.
-- Clean the adhesive surface, let it dry and apply primer. Refer to New Window Glass, Preparing for Installation .
Continuation for All Vehicles
-- Refer to Body Flange, Preparing for Installation .
-- Refer to INSTALLATION INSTRUCTIONS FOR BONDED WINDOWS .
-- Follow the MINIMUM CURING TIMES FOR BONDED WINDOWS .
The glass panel -1- can also be installed without the spacer -3-.
Conditions
- The outlet nozzle from the appropriate Electronic Parts Information must be adjusted using service equipment to reach the bead diameter dimension.
-- Apply window adhesive -2- on the marked adhesive surface of the glass panel -1-.
Dimensions for bead diameter:
- Dimension -a- = 8 ± 2 mm
- Dimension -b- = 13.5 ± 1.5 mm
-- Insert the glass panel -1- into the roof opening -3- using the Double Suction Lifter:VAG1344 .
Conditions
- Install the glass panel -1- within 10 minutes or the window adhesive will not bond well.
-- Center -4- the glass panel -1- with the centering pin -2- in the roof opening -3-.
If the centering pin -2- is not present, center -4- the glass panel -1- in the roof opening -3-.
-- Push down the glass panel -1- up to the spacer.
-- Check the body gap dimensions using the Gauge - Gap Adjustment:3371 . Pay attention to the appropriate Service Information when doing this.
Further installation is performed in reverse order of the removal.