Name Badges And Emblems On Sides, Replacing: Installing

-- Remove the adhesive residue and clean the adhesive surfaces. Refer to Installation Requirements for Components with Adhesive Tape .

Fender Name Badge

-- Position the name badge on the fender -1- at the same time pay attention to the dimensions.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

• Height dimension -a- = 11 mm
• Side dimension -b- = 0 ± 1 mm

Front Door Name Badge

-- Position the name badge on the door -2- flush to the name badge on the fender -1- while paying attention to the dimension:

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

• Side dimension -c- = 0 ± 1 mm

Continuation for All Vehicles

-- Press on the name badge.

-- Roll on the name badge using the Roller:T40400  in the area of the adhesive tape with 40 N to 50 N.

Conditions

• The minimum curing time must be complied to. Refer to Installation Requirements for Components with Adhesive Tape .