Side Sill Trim Panel, Removing And Installing: Installing
Install in the reverse order of removal while noting the following:
-- Remove the adhesive residue and clean the adhesive surfaces. Refer to Installation Requirements for Components with Adhesive Tape .
-- Press the side sill trim panel -1- with clips -4- into the grommets -5- in the side sill.
-- Align the side sill trim panel -1- in the longitudinal vehicle direction.
-- Tighten the bolt -6-.
-- Tighten the bolts -3-.
-- Remove the protective film upward and toward the rear by pulling on the double-sided adhesive tape -2-.
-- Firmly press the side sill trim panel -1- on evenly in area with the adhesive tape.
-- Press on the side sill trim panel -1- using the Roller:T40400 in the area with the adhesive tape, using a force of 50 N to 70 N.
Conditions
- The minimum curing time must be complied to. Refer to Installation Requirements for Components with Adhesive Tape .