Front Wheel Cover, Removing And Installing: Installing
Install in the reverse order of removal while noting the following:
-- Remove the adhesive residue and clean the adhesive surfaces. Refer to Installation Requirements for Components with Adhesive Tape .
-- Remove the protective film -5- using the pulling aids from the adhesive tape -6-.
-- Guide in the front wheel arch trim -1- in direction of -arrow C-.
-- Engage the clips -4- from the front wheel arch trim -1- into the fender in direction of -arrow B-.
-- Engage the hooks -3- from the front wheel arch trim -1- into the bumper cover in direction of -arrow A-.
-- Press on the front wheel arch trim in direction of -arrow A-.
-- Press on the front wheel arch trim using the Roller:T40400 in the area with the adhesive tape, using a force of 50 N to 70 N.
Conditions
- The minimum curing time must be complied to. Refer to Installation Requirements for Components with Adhesive Tape .
-- Tighten the bolts from the front wheel arch trim to the bumper.