Three-Phrase Current Drive VX54, Calibrating

Calibrating the Three-Phase Current Drive -VX54- is necessary if:

• The DTC memory for the relevant OBD systems was deleted.
• The Electric Drive Control Module -J841- software was updated.
• The Electric Drive Control Module -J841- was replaced.
• The Electric Drive Power and Control Electronics -JX1- was replaced.
• The Three-Phase Current Drive -VX54- was replaced.

The calibration is automatically performed during the first driving operation. Until the drive motor is successfully calibrated, the driving power is limited.

If the calibration is done manually:

-- Perform the "Electric Drive Motor, Calibrating" function using the Vehicle Diagnostic Tester . Refer to Diagnostic Entries .