Automatic High Beam Assist Control Module -J844-, REPLACING
The procedure for "replacing the automatic high beam assist control module" includes the following work to be completed:
- If a new Automatic High Beam Assist Control Module -J844- (new interior rearview mirror) is installed in the vehicle, then the Automatic High Beam Assist Control Module -J844- must be coded.
- Then the Automatic High Beam Assist Control Module -J844- must be adapted.
The procedure to "replace the automatic high beam control module" can only be performed with the Vehicle Diagnostic Tester in the "Guided Fault Finding " function.
Procedure
-- Replace the Automatic High Beam Assist Control Module -J844-. Use the Vehicle Diagnostic Tester Guided Fault Finding , replacing control module .