LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2021 >> Jetta SEL >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Diesel Fuel Injection System (General & Service Information - CVCA, CUUA, CUUB, DELA, DEBA, DEJA, DGMA)) >> 23 Diesel Fuel Injection >> Sensors >> Exhaust Pressure Sensor 1 -G450-, REMOVING AND INSTALLING >> Installing

Exhaust Pressure Sensor 1 -G450-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

NOTE:

Before installing, blow compressed air in the direction of the particulate filter to clean the control lines from the Exhaust Pressure Sensor 1 -G450- to the particulate filter (plugged or iced over due to condensation water).

Check the hose for secure fit and leaks.

Secure all hose connections with standard production hose clamps.

-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- After replacing the Exhaust Pressure Sensor 1 -G450-, reset the adaptation values with the Vehicle Diagnostic Tester.

scientia non olet · About LEMON Manuals