Throttle Valve Control Module -J338-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

NOTE:

Replace seals, and O-ring after removing.

-- When installing the intake tube with the Throttle Valve Control Module -J338-, pay attention to the alignment pins.

-- Install the upper front coolant pipes. Refer to OVERVIEW - COOLANT PIPES .

-- Install the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .