Overview - Rear Lid
WARNING: This page is about a different car, the 2018 Volkswagen Jetta, 2017 Volkswagen Jetta, 2016 Volkswagen Jetta, and 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
- Rear Lid
- Removing and Installing. Refer to REAR LID, REMOVING AND INSTALLING .
- Adjusting. Refer to REAR LID, ADJUSTING .
- Wiring Harness
- Adjusting Buffer
- Left and right
- Adjusting. Refer to REAR LID, ADJUSTING .
- Latch
- With emergency release
- Removing and Installing. Refer to LATCH, REMOVING AND INSTALLING .
- Hinge
- Removing and Installing. Refer to HINGES, REMOVING AND INSTALLING .
- Gas-Filled Strut
- Removing and Installing. Refer to GAS-FILLED STRUT, REMOVING AND INSTALLING .
- Venting. Refer to GAS-FILLED STRUT, VENTING .
- Striker
- Removing and Installing. Refer to STRIKER, REMOVING AND INSTALLING .
- Adjusting. Refer to REAR LID, ADJUSTING - Striker, Adjusting .
- License Plate Lamp
- Removing and installing. Refer to LICENSE PLATE LAMP .
- Rear Lid Release Button
- Removing and Installing. Refer to ACTUATOR, REMOVING AND INSTALLING .