Latch, Removing And Installing: Removing
WARNING: This page is about a different car, the 2018 Volkswagen Jetta, 2017 Volkswagen Jetta, 2016 Volkswagen Jetta, and 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
-- If equipped, remove the cap -1- in the direction of the -arrow- while releasing the locking tab -2-.
NOTE:
If the rear lid does not open, use the emergency release -4- through the rear lid trim panel to open it manually. Refer to the approrpiate service/repair/system information.
The emergency release -4- is only installed in certain markets.
-- Remove the rear lid trim panel. Refer to LUGGAGE COMPARTMENT TRIM PANELS .
-- Disconnect the connector -3- from the latch -1-.
-- Remove the nuts -2- and remove the latch -1- from the rear lid.