Latch Release Lever, Removing And Installing: Installing

WARNING: This page is about a different car, the 2018 Volkswagen Jetta, 2017 Volkswagen Jetta, 2016 Volkswagen Jetta, and 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

The lower A-pillar trim panel -4- is installed.

-- Slide the clip -2- into the release lever -1-.

-- Install the release lever -1- on the mounting bracket -3-.

Before closing the hood, make sure the release lever and the cable are working correctly.