LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2021 >> Jetta SEL >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Engine System (Cylinder Head & VALVETRAIN System - Service Information - 1.8L; 2.0L TFSI - CPLA, CPPA, CPKA, CPRA)) >> 15 Cylinder Head, VALVETRAIN >> Chain Drive >> Overview - Camshaft Timing Chains >> Bearing Bracket Tightening Specifications And Sequence

Bearing Bracket Tightening Specifications And Sequence

WARNING: This page is about a different car, the 2018 Volkswagen Jetta, 2017 Volkswagen Jetta, 2016 Volkswagen Jetta, and 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
GWWN15-11268Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

If an adapter sleeve is installed, it will be moved with the bolt -1- in the cylinder head.

-- Tighten the bolts in the steps shown in the sequence:

Bearing Bracket with Adapter Sleeve and Steel Bolts 

Step Bolt Tightening Specification/Additional Turn for Steel Bolts
1. -1- 3 Nm
2. -1 to 6- 9 Nm
scientia non olet · About LEMON Manuals