Drive Plate, Removing And Installing: Installing
WARNING: This page is about a different car, the 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
-- Set drive plate in place, using washer with notches -1-.
-- Install the new bolts -3- and tighten to 30 Nm.
-- Measure the dimension -a- at 3 different outer holes in the drive plate (offset 120°), and then calculate the average.
- Specified value for dimension a: 19.5 to 21.1 mm
NOTE:
This is measured through the hole in the drive plate to the machined surface of the cylinder block. Disengage the intermediate plate. Refer to Identifying Intermediate Plate Alignment Bushing .
If the specification is not obtained:
-- Remove the drive plate one more time and use the shim -2-. Tighten bolts -3- again to 30 Nm.
-- Tighten the bolts on the drive plate.
Additional turn can occur in several stages.