Ribbed Belt, Removing And Installing: Installing
WARNING: This page is about a different car, the 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Pay attention to the following:
NOTE:
Make sure all assemblies (generator, A/C compressor and power steering pump) are installed securely before installing the ribbed belt.
Make sure the running direction of the ribbed belt is correct and that the belt is routed correctly over the belt pulley.
Route the ribbed belt last over the generator on vehicles without an A/C system.
Route the ribbed belt last over the A/C compressor on vehicles without an A/C system.
After the work is completed:
-- Start the engine and check the belt running.
Belt Drive Without A/C Compressor
Belt Drive With A/C Compressor