Crankshaft Seal, Replacing, Belt Pulley Side: Installing

WARNING: This page is about a different car, the 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Do not oil the sealing lip and outer edge of seal before installing it.

-- Remove any oil residue on the crankshaft pins with a clean cloth.

-- Attach the :T10053/1 guide sleeve on crankshaft pin.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Slide seal over guide sleeve onto the crankshaft pin.

-- Press in seal using the thrust sleeve from the :T10053 and the :T10053/2 (M16 x 1.5 x 60) until it stops.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the crankshaft toothed belt sprocket. To do so, lock the toothed belt sprocket using the :3415 .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install a new central bolt.

The central screw threads and shoulder must be free of oil and grease.

Additional turn can occur in several stages.

-- Install the toothed belt. Refer to TOOTHED BELT, REMOVING AND INSTALLING .

-- Install the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .