Vibration Damper Sealing Ring, Replacing: Installing

WARNING: This page is about a different car, the 2018 Volkswagen Jetta, 2017 Volkswagen Jetta, 2016 Volkswagen Jetta, and 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Clean the contact and sealing surface.

-- Push the seal -arrow- on the :T10354 .

The closed side of the seal points to the :T10354 .

-- Push the seal -arrow- with the :T10354 on the :T10531/2 and place on the lower timing chain cover.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Additionally attach the :T10375 and tighten the :T10531/4 .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Drive the seal in all the way using the :T10354 .

NOTE:

Replace the vibration damper bolt.

Replace the O-ring.

Further assembly is performed in the reverse order of the removal. Note the following:

-- Install the vibration damper. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .