LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2021 >> Jetta SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Engine System (Cylinder Head & VALVETRAIN System - Service Information - 1.8L; 2.0L TFSI - CPLA, CPPA, CPKA, CPRA)) >> 15 Cylinder Head, VALVETRAIN >> Cylinder Head >> Vacuum Pump, Removing And Installing >> Installing

Vacuum Pump, Removing And Installing: Installing

WARNING: This page is about a different car, the 2018 Volkswagen Jetta, 2017 Volkswagen Jetta, 2016 Volkswagen Jetta, and 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
GWWA47-10091Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Clean the sealing surfaces.

-- Turn the vacuum pump coupling plate so that it engages in the camshaft groove when installing the vacuum pump.

-- Position the new seal on the vacuum pump and insert the two bolts. Position the vacuum pump with the seal on the cylinder head.

-- While doing so pay attention that it lays flush on the flange.

Further assembly is performed in the reverse order of the removal.

-- Install the high pressure pump with >>roller tappet<<. Refer to HIGH PRESSURE PUMP, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals