Cooling System Charge Kit - Electric Vacuum Pump :VAS6096/2, CHECKING

WARNING: This page is about a different car, the 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required

Cooling System Charge Kit :VAS6096
Cooling System Charge Kit - Electric Vacuum Pump :VAS6096/2

NOTE:

Before using the :VAS6096 and the :VAS6096/2 , a check must be performed to ensure that the cooling system is filled correctly.

-- Connect the hose -1- of the :VAS6096/2 to the connector coupling -B- on the :VAS6096 .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Connect the :VAS6096/2 on the vehicle battery and switch on.

-- Close valve -A- and open valve -B-.

-- The needle on the pressure gauge -arrow- must move until it is well below the green area.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Close the valve -B- and switch off the :VAS6096/2 .

-- Monitor the vacuum on the pressure gauge for 10 seconds. The needle must not move.

If Not Enough Vacuum Builds Up, Or The Pressure Continues To Increase:

The :VAS6096 , the pressure gauge or the :VAS6096/2 is leaking or faulty and must not be used.