Heater Support Pump -V488-, REMOVING AND INSTALLING, VERSION 3: Installing

WARNING: This page is about a different car, the 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

NOTE:

Secure all hose connections with standard production hose clamps.

If the Heater Support Pump -V488- was removed from the bracket

-- Slide the Heater Support Pump -V488- into the bracket -3-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pay attention to the installation position while doing this.

-- The raised section on the pump must sit in the opening -arrows- as shown.

-- Slide in until the tabs -5- engage behind the bracket -3-.

-- Check that it is positioned correctly by gently pulling on it.

-- Check the coolant level. Refer to COOLANT, FILLING .