LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2021 >> Jetta SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Engine Cooling System (General & Service Information - CVCA, CUUA, CUUB, DELA, DEBA, DEJA, DGMA)) >> 19 Cooling System >> Coolant Pump/Coolant Regulation >> Electric Coolant Pump, Removing And Installing >> Heater Support Pump -V488-, REMOVING AND INSTALLING, VERSION 2 >> Installing

Heater Support Pump -V488-, REMOVING AND INSTALLING, VERSION 2: Installing

WARNING: This page is about a different car, the 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

NOTE:

Secure all hose connections with standard production hose clamps.

If the Heater Support Pump -V488- was removed from the bracket

-- Make sure the rubber bushing is seated correctly in the bracket.

-- Make sure the spacer sleeves are seated correctly in the rubber bushing.

-- Tighten the bolts.

-- Check the coolant level. Refer to COOLANT, FILLING .

scientia non olet · About LEMON Manuals