Overview - Glow Plug System

WARNING: This page is about a different car, the 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Glow Plug System Components Location

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Camshaft Position Sensor -G40-
- Removing and installing. Refer to Camshaft Position Sensor -G40-, REMOVING AND INSTALLING .
Bolt
- 9 Nm
O-ring
- No replacement part, replace the camshaft position sensor if damaged
Glow Plug:
- Glow Plug 1 -Q10-
- Glow Plug 2 -Q11-
- Glow Plug 3 -Q12-
- Glow Plug 4 -Q13-
- If equipped Glow Plug 3 -Q12- with the Cylinder 3 Combustion Chamber Pressure Sensor -G679-
- Glow plug versions. Refer to figure in Overview Glow Plug Versions .
- Removing and installing. Refer to GLOW PLUG, REMOVING AND INSTALLING .
- Glow plug without combustion chamber pressure sensor 17 Nm
- Glow plug with combustion chamber pressure sensor 12 Nm
Connector
- For the glow plug
Transmission Side Sealing Flange
- Removing and installing. Refer to SEALING FLANGE, REMOVING AND INSTALLING, TRANSMISSION SIDE .
Sensor Wheel
- For the Engine Speed Sensor -G28-
- Removing and installing. Refer to OVERVIEW - CYLINDER BLOCK, TRANSMISSION SIDE .
Engine Speed Sensor -G28-
- Removing and installing. Refer to Engine Speed Sensor -G28-, REMOVING AND INSTALLING .
Bolt
- 4.5 Nm