LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2021 >> Jetta SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (Lubrication System (Service Information - 2.0L, - CVCA, CUUA, CUUB, DELA, DEBA, DEJA, DGMA)) >> 17 Lubrication >> Oil Pan/Oil Pump >> Oil Pan Upper Section, Removing And Installing >> Installing >> Continuation For All Procedures

Continuation For All Procedures

WARNING: This page is about a different car, the 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

-- Insert the splash wall.

-- Position the oil pan upper section and tighten the bolts. Refer to Figure.

NOTE:

The three bolts -10 to 12- are specially coated with sealing paint, pay attention to the allocation when installing.

Allocation of the bolts.

Replace the bolts.

When installing the oil pan upper section to a removed engine, make sure that the oil pan upper section is positioned flush with the cylinder block on the flywheel side.

Allow the sealant to dry for approximately 30 minutes after installing the oil pan upper section. Only afterward may the engine oil be replenished.

-- Fill the engine oil and check the oil level.

scientia non olet · About LEMON Manuals