Valve Guides, Checking
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Dial Indicator Holder: VW387
- Dial Indicator - 0-10mm: VAS6079
Test Sequence
-- Insert the valve into guide. The valve stem end must be flush with the guide. Due to differences in valve stem diameter, only use intake valves in intake valve guides, and exhaust valves in exhaust valve guides.
-- Determine the tilting clearance.
Wear Limit
| Intake Valve Guide | Exhaust Valve Guide |
|---|---|
| 0.80 mm | 0.80 mm |
NOTE:
If the wear limit is exceeded, measure using new valves. Replace the cylinder head if the wear limit is still exceeded.
If the valve is replaced during a repair, use a new valve for measurement.