Pistons, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

-- Secure the engine on the : VAS6095A . Refer to ENGINE, SECURING TO ENGINE AND TRANSMISSION HOLDER .

-- Remove the cylinder head. Refer to CYLINDER HEAD, REMOVING AND INSTALLING .

-- Remove the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .

-- Label the installation position and allocation of the piston to the cylinder.

-- Label the installation position and allocation of the connecting rod to the cylinder -item ) OVERVIEW - PISTONS AND CONNECTING ROD - List Item: Connecting Rod.

-- Remove the connecting rod bearing cap and remove the piston and connecting rod upward.

NOTE:

If difficult to move, heat the pistons to approximately 60 °C (140 °F).

-- Remove the circlip from the piston pin eye.

-- Remove the piston pin using the : VW222A .