Pistons, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal and note the following:

NOTE:

Replace the bolts that were tightened with an additional turn.

Arrow on the piston crown points toward belt pulley side.

Piston ring gap offset 120°.

-- Coat the contact surfaces on the bearing shells with oil.

-- Install the piston with a commercially available piston ring compressor. Pay attention to the installation position -item ) OVERVIEW - PISTONS AND CONNECTING ROD - List Item: Piston.

-- Install the connecting rod bearing cap. Pay attention to the installation position -item ) OVERVIEW - PISTONS AND CONNECTING ROD - List Item: Connecting Rod Bearing Cap.

-- Install the cylinder head. Refer to CYLINDER HEAD, REMOVING AND INSTALLING .

-- Install the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .