Flywheel, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Dual-Mass Flywheel & Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Remove the bolts -B- by hand. Do not use an air-powered or impact wrench.

When removing the bolts, make sure that the bolt head does not come in contact with the flywheel.

Turn the flywheel -A- so that the bolts -B- line up with the center of the holes -arrows-.

-- Insert the : 3067 into the hole -B- on the cylinder block.

Fig 2: Identifying Flywheel Retainer

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Loosen and remove the bolts for the flywheel.