Sub-Assembly Bracket, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal and note the following:

NOTE:

Replace the bolts that were tightened with an additional turn.

Replace the O-rings and seals.

-- Coat the new O-rings -4- with coolant.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the connection pieces -2- into the engine oil cooler -1-.

-- Slide the sub-assembly bracket with the engine oil cooler -1- onto the connection. Position the bolts and tighten. Refer to Figure.

-- Install the generator. Refer to GENERATOR, REMOVING AND INSTALLING .

-- Install the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Fill with coolant. Refer to Filling .

-- Install the oil filter and then check the oil level. Refer to ENGINE OIL, DRAINING, REPLACING OIL FILTER AND FILLING ENGINE OIL .